Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
STARTING AND STOPPING THE BLOWER (See Figs. 13-17)
For cold start:
■ Make sure that the battery pack is securely in place.
■ Place the blower on a level surface, outdoors.
■ Press the primer bulb 5 times.
■ Turn the choke lever to the CHOKE position (Fig. 13).
■ Lift the start button cover and press the start button until the engine starts (Fig. 14 & 15). Then
engage the throttle lever to start the blower (Fig. 16). The choke lever will automatically switch to
RUN position.
NOTE: If the engine does not start, repeat step 5 until the engine starts.
■ If the blower fails to start, check the Troubleshooting section in the manual.
NOTE: This 2-cycle blower is equipped with an automatic choke reset. The user must switch the choke
lever to CHOKE position for cold starts. As soon as the throttle lever is engaged, the choke lever will
automatically switch to the RUN position.
NOTE: After the engine starts and runs, release the throttle lever and allow the blower to warm up at
idle for several minutes.
For warm start:
■ Make sure that the battery pack is securely in place.
Fig. 14
Fig. 13
START
Fig. 15
20
Fig. 16
Publicidad
