Adler europe AD 7807 Manual De Uso página 4

sink filled with water.
15. The heater should be placed on a level, heat-resistant surface, away (at least one
meter) from flammable materials (lace curtains, curtains, wallpaper, furniture etc.).
16. The power cable should not be placed above the heater, and also should not touch or
lie close to hot surfaces. Do not place the heater under an electrical outlet.
17. The surface of the heater can heat up to high temperatures of over 60 degrees C. Take
care when near the heater.
18. Do not cover the heater with curtains, a towel or hang washing on it – this can damage
the heater or cause a fire.
19. When using the heater, completely unwind its cable and make sure that the cable is not
touching the hot surface of the heater.
20. Do not use the heater near basins, showers, sinks, pools or other places where it can
get wet.
21. The device must be completely cool prior to storage. Keep the original packaging to
store the heater in during non-heating seasons.
22. The heater is filled with a set amount of special oil. Repairs requiring opening of the oil
container must be carried out only by the manufacturer or authorized representative, who
should be contacted if oil leaks from the heater.
23. If disposing of the heater please follow rules of oil disposal.
WARNING: To avoid overheating do not cover the heater.
DESCRIPTION OF THE DEVICE (Fig. 1)
1. Diode indicating operation of the device
2. Thermostat control knob
3. On-switch control knob
4. Cable storage
5. Wheels
6. Ribs
ASSEMBLY (Fig. 2)
1. Turn the heater upside down.
2. Place the wheel bases between the last ribs.
3. Use the U-shaped clamp to hook the bases.
4. Block the clamp by screwing on the butterfly nut.
5. Place the heater on the wheels.
CAUTION: After turning the heater, wait at least one hour before connecting it to a power outlet.
USING THE DEVICE
CAUTION: During first use of the heater a small amount of smoke may appear. This is normal.
1. Place the oil heater a minimum of 100 cm from walls, furniture, curtains, plants etc.
2. Make sure that the on-switch control knob (3) and thermostat control knob (2) are set to '0'. Connect the oil heater to mains power.
3. Turn the heater on by turning the on-switch control knob (3) to position 1 (low heating power) or 2,3 (high heating power). Set a
comfortable oil heater temperature by turning the thermostat control knob.
4. After you finish using the heater, turn it off by turning the on-switch control knob and thermostat control knob to '0' and disconnect the
power cable from mains power.
CLEANING THE DEVICE
1. Prior to cleaning always remove the plug from the electrical outlet.
2. Prior to cleaning allow the heater to cool. Make sure that it is cool.
3. Wipe the heater with a damp cloth, then wipe dry.
4. Never use wax, shining agents or chemical agents to clean the heater. They may react with the device and cause discoloration or
even damage.
4