Publicidad
208036
ON
OFF
START
701026
208041
EMU00950
Emergency Starting Engine
1) Remove the top cowling.
2) Remove the start-in-gear protection
cable from the starter if equipped it.
3) Remove the starter/flywheel cover
after removing the bolt(s).
4) Prepare the engine for starting. See
"STARTING ENGINE" for procedures.
Be sure the engine is in Neutral and
that the lock plate is attached to the
engine stop lanyard switch. The main
switch must be "ON" if equipped it.
5) Pull out the choke knob when a cold
engine starts. After the engine start,
return the choke knob.
6) Insert the knotted end of the emer-
gency starter rope into the notch in
the flywheel rotor and wind the rope
several turns clockwise.
7) Give a strong pull straight out to
crank and start the engine. Repeat if
necessary.
5-7
GB
Publicidad
