Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
before using the appliance again.
7.1.
Cleaning the boiler
a) The machine has to be cold and the electrical plug disconnected. With a wrench n° 22 open
the stopper under the machine and empty completely all remaining water in the boiler.
When the boiler is empty, close the stopper carefully but without exceeding.
b) Control visually or with a rod the remaining water quantity in the cold water tank : for
about 1,5 litter water take 1,5 litter.
c) Connect the electrical plug, switch on the main switch 1. Wait until the pump finishes to fill
the boiler and stops (it's possible that the indicator light for lack of water 6 goes on and that
you hear the acoustic signal). Switch off the machine, disconnect the electrical plug and leave
the machine for 8 hours.
d) Empty the loose limestone in the solution and rinse the boiler proceeding as per point A.
e) Fill the cold water tank with clean water and switch on the machine. For about 10 minutes use
steam with care, because it will have a sharp smell because of the remaining vinegar in the
boiler and in the conducts.
f) When the operation boiler cleaning is completed, to start the appliance again, follow the
instructions explained under Starting.
Troubleshooting
8.
Water is leaking from the accessories
Plug of the steam hose is difficult to insert in the
socket of the machine.
Boiler needs more time to heat up
Pressure goes down quickly while using steam
Warranty
9.
Warranty conditions:
•
The warranty does not cover damages deriving from normal wear.
•
The warranty does not cover damages or accidents due to non-respect of the instructions of this
manual, bad servicing or improper use of the appliance.
•
The warranty comprehends replacement and / or repair of faulty parts, including workmanship.
Under no circumstances the acknowledgement of the warranty involves an acknowledgement of
damages or claims of any type or cause.
•
Transport and packing costs are at the purchaser's charge.
Waste and Recycling
10.
Do not discard the components of the appliance in the environment. For their waste, the laws of the
country where the appliance is used have to be observed.
Data, specifications and equipment which are described in this document are not binding and may be
altered without prior notice.
ANOMALY
Due to wear or damage of seals –Replace the seals
on the coupling paying attention not to cut or to
mark them and to place them carefully.
Do not force to insert it, but put a bit of silicon on
the steam coupling in the machine.
Clean the boiler as explained.
Symptom of limestone, clean the boiler as
explained.
13
SOLUTION
Publicidad
Tabla de contenido
