peerless-AV SC550GL Instalación Y Ensamblaje página 9

For Flat Back Display
6-1
Begin with the shortest length screw, hand thread screw through multi-washer and display brackets (B) into
display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
overtighten. If screw cannot make three full turns into the display, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of display.
For Bump-out or Recessed Back Display
6-2
Begin with the longest length screw, hand thread screw through multi-washer, display brackets (B) and spacer in
that order into display as shown. Screw must make at least three full turns into the mounting hole and fi t snug into
place. Do not overtighten. If screw cannot make three full turns into the display, select a shorter length screw from
the baffl ed fastener pack. Repeat for remaining mounting holes, level display brackets and tighten screws.
DISPLAY
B
DISPLAY
SPACER (HH)
B
9 of 35
MULTI-WASHER (GG)
SCREW
(AA,CC,EE)
MULTI-WASHER (GG)
SCREW
(BB,DD,FF)
ISSUED: 02-25-11 SHEET #: 009-9049-5 06-16-14