Before Using For The First Time; Setting Up The Machine; Important; Brewing Coffee - Bella 14015 Manual De Instrucciones

Before Using for the First Time

CAUTION: To protect against electrical shock, do not immerse the Coffee maker or allow power cord to come into
contact with water or other liquids.
1. Remove all packing material and labels from the inside and outside of the Coffee maker. Place the coffee
maker on a flat, clean surface.
2. Before preparing coffee, thoroughly clean the glass carafe with lid, removable filter holder and permanent
coffee filter in hot, sudsy water. Rinse and dry. Replace disassembled parts. See Care & Cleaning
Instructions for a detailed description.
3. Clean the inside of the Coffee maker by brewing 2 full carafes of tap water (see "setting up the machine").
Do not add the permanent coffee filter or ground coffee for this initial cleaning.
NOTE: At the end of the first cycle, allow 15 minutes for the coffee maker to cool.
4. Brew a second carafe of fresh water.
5. Wait an additional 15 minutes to allow the coffee maker to cool before brewing your first carafe of coffee.

Setting up the machine

IMPORTANT: Before brewing, always check to make sure water level inside the water tank is past the 2 cup line
and add water if needed. Never exceed the 12 cup fill line.
NOTE: The amount of brewed coffee will always be less than the amount of water placed into the water
reservoir; as much as 10% is absorbed by coffee grounds and filter.
NOTE: At any time press the
1. Lift to open the Coffee maker lid. Fill carafe with cold tap water to the desired line and pour into water reservoir
at the back of the coffee maker. The stepped water level indicator can be easily viewed inside coffee maker.
2. Place empty carafe on the keep warm plate.
3. For added convenience, remove the permanent filter. Measure 1 level tablespoon or 1 scoop with the
provided scoop of drip or regular ground coffee for each cup of coffee desired. For stronger or milder
coffee, adjust amount of ground coffee to suit your taste.
4. Replace the permanent filter back into the filter holder and place back into the coffee maker. Close the lid.
5. Plug the power cord into 120V/60HZ power supply socket, the LCD background indicator will illuminate in
blue and "AM 12:00" will be displayed on the LCD. At that time, "12" will flash while ": 00" will steadily
light. To set the hour select between
minute "00" will now flash. Again, toggle between the
confirm push the
NOTE: The backlight indicator will go into sleep mode within 15 seconds if no further buttons are selected.

Brewing coffee

1. Press button to start the brew cycle. One beep will sound and the
maker will begin the brew cycle.
NOTE: To interrupt the brew process at any time, press the
and the light in the button will go out. The screen will display the clock.
2. Upon completion of the brew cycle, wait at least 1 minute until the dripping coffee from the flow valve
into the carafe has stopped. The carafe lid should be kept in place to facilitate safe serving and help keep
coffee at a proper serving temperature. Tilt the carafe slightly and pour the hot coffee very slowly, so that
the flow of the brewed coffee does not exceed the width of the spout.
3. Once the brew cycle is complete, the coffee maker will beep and will go into the keep-warm mode. At that time
the LCD will show the
reaches the preset keep warm time, three beeps can be heard and the
4. During the
or when the coffee maker is not in use.

Setting the clock

1. Press and hold the
current hour will flash.
2. Press button once to increase the hour by one increment each time, or hold the button to increase
quickly. Press
quickly. Once your desired hour time is achieved, press the
3. At that time, the current minute digits will illuminate and flash.
4. Again, press the
minute each time. Both buttons can be held to increase the minutes quickly. Once the desired minute has
been reached, press the
5. The coffee maker will automatically switch from AM to PM once the hour passes 12.
6. If a mistake was made or to exit the clock setting mode, wait 15 seconds and the LCD will show the last
clock setting.
button to begin brew cycle.
button. The coffee maker will beep.
icon. The keep warm time will count up from 0:00. When the coffee maker
mode press the button once to turn the Coffee maker off when the carafe is empty
button for 3 seconds to enter into the clock-setting mode. The LCD will illuminate and the
once to decrease the hour by one increment each time, or hold the button to decrease
button once to increase one minute each time and press
button to confirm. One beep can be heard and the set time will appear.
and . Once the desired hour is reached push the
and
button once. The coffee maker will beep
5
buttons to reach the desired minute. To
button will illuminate. The Coffee
icon will disappear.
button to confirm.
once to decrease one
button. The