Electrolux LB15A Guía De Uso página 13

CLEANING AND MAINTENANCE
Lint Filter
The lint filter function is to retain the eliminated
lint from clothes during washing. To preserving
and efficiency of this filter is recommended
clean it after each washing cycle.
For models with agitator: turn and pull the
lid of the agitator upwards (1A). Press the side
locks (2A) to remove the filter. Wash the filter in
water and, if necessary, use a small brush (3A)
that does not damage the mesh filter. Place the
filter on its housing, ensuring that it is properly
positioned. Place the lid in the agitator and
attach it until the end.
For models with impeller: pull the filter through
the upper latch (1B) until the disconnection.
Then pull (2B) upwards to remove the bracket.
To open the inner filter, press the upper latch (2)
and tilt the internal filter (3), allowing cleaning.
Wash with running water and, if necessary, use
a brush that does not damage the filter mesh.
To replace, rotate the inner filter to catch again,
and replace the filter holder, making sure it is
properly seated.
The accumulation of lint in the filter can cause
the clogging in the mesh. To clean the filter,
use only running water. Do not use cleaners
or brushes which can damage the filter mesh.
During washing of colored clothing, the
release of dyes can occur, dyeing the filter
mesh.
Internal Part
Clean the inside of the washing machine at
least once a month. Put 1 liter of bleach in the
drum. Select the High water level and the Stain
Removal program. Let the washing machine
complete the cycle to ensure the complete
removal of bleach.
This cleaning should be done to prevent spots
in clothes, caused by accumulated waste in the
washing machine due to excessive use of soap
and softener.
Water Filter
Close the water inlet. Disconnect the end of
the hose from the faucet and remove the filter.
Clean the filter with a flush of water. If you
have difficulties when removing the impurities,
use a small soft brush. This procedure should
be done periodically to prevent the filter
clogging. If the filter is damaged and needs to
be changed, call Frigidaire Service Center. Do
not forget to replace the filter in the hose and
open the faucet again. The machine should
not be used without the filter under the risk of
damage the product.
Dispenser Drawer
To clean the dispenser, proceed as follows:
1
3
1. Open the drawer completely.
2. To remove, push the drawer up so that the
drawer bolts clear the rails, allowing the
drawer to be removed.
3. If necessary, the inside can be cleaned using
a small brush.
The pieces of the drawer can be cleaned using
water, soap, a cloth or a brush to remove small
wastes.
2
13