Descargar Imprimir esta página

Swisher Trim-Max STD67522BS Manual Del Propietário página 10

Ocultar thumbs Ver también para Trim-Max STD67522BS:

Publicidad

Idiomas disponibles

Idiomas disponibles

Head Engagement Belt Z Replacement
1.
Remove front belt cover.
2.
Remove old belt.
3.
Install new belt by first routing belt under the engine and around engine pulley Y .
4.
Then route belt around upper power transfer pulley V .
5.
Ensure idler pulley W is located on the outside of belt as shown.
6.
Ensure that belt is correctly installed in the grove of each pulley.
7.
Reinstall front belt cover.
8.
If belt tension had previously been adjusted, reset thumb wheel adjuster by rotating wheel clockwise as far as
adjuster will allow (see illustration in belt adjustment instructions). If head does not properly engage refer to
belt adjustment instructions.
Power Transfer Belt T Replacement
1.
Remove front belt cover.
2.
Remove Head Engagement Belt Z .
3.
Loosen tilt handle X .
4.
Push trimmer head toward back of unit, compressing tensioner spring.
5.
Remove old belt.
6.
Install new belt by first routing belt around lower power transfer pulley U .
Then route belt around front pulley S . CAUTION – Pinch Hazard: Ensure that you do not get any part of
your body between the belt and the pulleys as this may cause injury.
8.
Release trimmer head and tighten tilt handle per operating instructions.
9.
Reinstall Head Engagement Belt per instructions above.
10.
Reinstall front belt cover.
11.
If head does not properly engage refer to belt adjustment instructions.
10

Publicidad

loading

Este manual también es adecuado para:

L213-255001