Publicidad
Idiomas disponibles
Idiomas disponibles
Main burner
Match light
1.
If the burner will not light after several attempts then the burner can be match lit, before using the match
allow 5 minutes for any accumulated gas to dissipate.
2.
Clip a paper match on one end of the lighting rod.
3.
Light match.
4.
Hold lighting rod and insert lighted match right next to the burner ports or ceramic file.
5.
Push and turn the designated control knob to
6.
Burner should ignite immediately.
Lighting Instructions
Make sure the lid is open.
1
Push and turn the control knob to "
same time, press and hold electronic ignition button to light
2
the burner . Once the burner is lit, release the electronic
ignition button and knob.
3
If burner does not light within 5 seconds, turn the knob to
OFF position and repeat the lighting procedure.
If burner fails to light after step 3, turn the knob to OFF
4
position, wait 5 minutes, then repeat the lighting procedure
or light by match.
/HIGH.
11
/HIGH", at the
Side burner
continued
Publicidad
