Publicidad
Idiomas disponibles
Idiomas disponibles
ROTATING BRUSH
1.
Open the cover of the rotating brush to remove it. Please note the lock symbols.
2.
Remove the cover and take the brush out of the appliance.
3.
Remove dirt and hair from the brush. If necessary, use scissors.
4.
Put the brush back in the appliance. Make sure that the belt is back on the sprocket.
5.
Put the cover back on the appliance and tighten it into position. Please note the lock symbols.
1
UV LIGHT
To guarantee an optimal functioning of the UV light, the lamp needs to be cleaned regularly. Make sure
you will not leave any finger prints on the lamp after cleaning, as this can
influence the operation of the lamp.
1.
Remove the screws and the cover of the UV light.
2.
Clean the lamp using a soft, dry cloth.
3.
Replace the cover and the screws after cleaning.
4.
In case of a defect of the lamp, contact the after sales service. The lamp
needs to be replaced by the repair service.
PROBLEM AND SOLUTION
Problem
The appliance does not work.
Loss of suction.
The UV light does not work.
The appliance suddenly stops
working.
www.domo-elektro.be
4
2
·
Check that the plug is correctly inserted into the socket.
·
Press the on/off button.
·
The cotton filter is saturated. Clean the cotton filter.
·
The filter is dirty/the dust reservoir is full. Clean the
appliance as described in this manual.
·
The UV light is too far away from the surface to be cleaned.
Move it closer.
·
The appliance is not in a horizontal position. Hold the
appliance horizontally.
·
The UV light is dirty. Clean it as described in this manual.
·
The UV light is damaged. Contact the after-sales service.
·
The filter is dirty/the dust reservoir is full. Clean the
appliance as described in this manual.
·
The appliance is overheated. Unplug the appliance and let
it cool down for two hours before using it again. Clean it
thoroughly.
5
Solution
25
DO234S
Publicidad
