Publicidad
Idiomas disponibles
Idiomas disponibles
Indicating the remaining battery capacity
Only for battery cartridges with the indicator
Fig.5
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
NOTE: The first (far left) indicator lamp will blink when
the battery protection system works.
Appliance / battery protection system
The appliance and battery are equipped with the protec-
tion system. This system automatically cuts off power
to the motor to extend appliance and battery life. The
appliance will automatically stop during operation if the
appliance or battery is placed under one of the following
conditions.
•
Overload protection : When the appliance or
battery is operated in a manner that causes it to
draw an abnormally high current, the appliance
automatically stops without any indication. In
this situation, turn the appliance off and stop the
application that caused the appliance to become
overloaded. Then turn the appliance on to restart.
1
2
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
•
Overheat protection : When the appliance or
battery is overheated, the appliance automatically
stops. Let the appliance cool down before turning
it on again.
•
Overdischarge protection : When the battery
capacity becomes low, the appliance stops auto-
matically. If the appliance does not operate even
when the switches are operated, remove the
battery cartridge from the appliance and charge it.
Protections against other causes
Protection system is also designed for other causes that
could damage the appliance and allows the appliance to
stop automatically. Take all the following steps to clear
the causes, when the appliance has been brought to a
temporary halt or stop in operation.
1.
Turn the appliance off, and then turn it on again to
restart.
2.
Charge the battery(ies) or replace it/them with
recharged battery(ies).
3.
Let the appliance and battery(ies) cool down.
If no improvement can be found by restoring protection
system, then contact your local Makita Service Center.
OPERATION
Preparation
When using the appliance for the first time, or after long
period of storage, perform the following steps.
1.
Remove all packing materials from the appliance.
2.
Clean the interior of the kettle and filter. There may
be dirt such as dust on them.
See the chapter "MAINTENANCE" for how to clean.
Boiling water
CAUTION:
Boil only water. Do not boil other
than water.
CAUTION:
Do not put the appliance on an
unstable place, a place where people often pass,
or a place where children can reach. Otherwise the
appliance may be accidentally tipped over and cause
an injury.
CAUTION:
When closing the lid, push the
lid securely and put the discharge lock button in
locked position. Otherwise burn injury may occur
when falling accident occurs.
1.
Open the lid while pushing both of the open-lid
buttons.
7 ENGLISH
Publicidad
