Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Pour preferred amount of fresh tepid water into the
kettle. Then close the lid.
CAUTION:
Make sure the discharge lock
button is in locked position. Otherwise boiled water
may be spilled unintentionally and cause burn injury.
CAUTION:
Do not over fill water exceeding
the maximum line. Otherwise boiled water may be
ejected and cause burn injury.
NOTICE:
Prevent no-water burning, do not turn
on the appliance without water. Otherwise discolor-
ation or malfunction may occur.
Fig.6
3.
Put the kettle onto the power supply stand.
Fig.7
4.
Push the power switch.
The power switch lights up in orange with single beep
sound, then boiling starts.
1
Fig.8
► 1. Power switch
CAUTION:
Do not touch the steam. Risk of
burn injury.
Fig.9
CAUTION: Do not touch around
the metal part located in the figure during boiling
or some time after boiling. Risk of burn injury.
Fig.10
► 1. Metal part that may extreme hot
NOTE: If you press the power switch right after boil-
ing operation, the appliance may not work due to the
protection against high temperature. In this case,
allow the appliance to cool and then press the power
switch again.
When the boiling is finished, the appliance turns off
automatically with a few seconds of beep sound.
NOTE: When you lift the kettle or the power supply
stand while boiling, the appliance stop boiling and the
power switch blinks in orange.
—
If you return the kettle or the power supply stand
while the power switch is blinking, the appliance
restarts boiling automatically.
—
Few seconds after you lift the kettle or the power
supply stand, the appliance turns off.
NOTE: When the battery capacity becomes low
while boiling, the appliance turns off and the power
switch blinks in red for a few seconds with three beep
sounds.
NOTE: If you turn on the appliance when at least one
battery capacity is low, the appliance turns off within a
few seconds with a single beep sound.
8 ENGLISH
mark and
1
Publicidad
