Publicidad
Idiomas disponibles
Idiomas disponibles
Monthly Inspection
• Check for any drop in performance. Reduced performance is usually caused by debris
blocking the intake screen.
• Unplug the power cable from the receptacle or turn off the power supply (circuit breaker).
• Disconnect the pump discharge and remove the pump from the water.
• Remove any accumulated debris from the surface of the pump and inlet screen.
• Remove the two screws that secure the intake screen and inspect and clean the impeller
before reattaching screen.
• Do not disassemble the pump motor for any reason. Disassembly will void the pump
warranty. Refer operating and maintenance problems to a qualified technician.
Winterizing
• Under no circumstances should the pump be left in frozen water.
• Before storing the pump for an extended period, wash and dry thoroughly, then
store indoors.
Note: Always run a test operation before putting the pump back into operation. When the
pump is left installed in water it should be run at regular intervals (about once per week).
Warranty
The TidalWave TUP2000 Pump carries a two-year limited warranty. This limited warranty is
extended solely to the original purchaser commencing from the date of original purchase
receipt and is void if any of the following apply:
• The pump has been run dry.
• The pump was not run on a dedicated circuit.
• The cord has been cut or altered.
• The pump has been misused or abused.
• The pump has been disassembled other than as described in this manual.
• Serial number tag has been removed.
Warranty Claims
In case of warranty claims, pump should be returned to place of purchase accompanied
by original receipt.
4
Publicidad
