Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 3: Pump Replacement/Reassembly
1. Lubricate the Canister Gasket
4
down, place the Gasket into the inner groove at the bottom.
9
2a. If your Pump is removed from the pool, slowly insert the Motor Assembly
back into the upside-down Canister. There's a rib on the inside of
Canister (only visible from bottom), which needs to be aligned with an
indent at the bottom of the Motor.
Close Up
BOTTOM VIEW OF PUMP & CANISTER
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8AM to 5PM MST, Monday-Friday.
. Turn the Skimmer Canister
9
upside
4
Extended operating days and hours during peak season requirements.
OWNER'S MANUAL
IMPORTANT: make sure that the cord of the
Motor Assembly
3
is placed through the Motor
Seal Nut
1
BEFORE replacing the Pump.
2
2b. If your Pump is left attached to the pool, reach in through the Canister to
pull the Motor Assembly up and insert it back into the Canister. Make sure
to align the Rubber Nozzle
2
with the hose opening of the Canister,
otherwise the Pump may leak even already locked in place.
TOP VIEW
Outlet of Canister and
Rubber Nozzle
on the
2
pump should be aligned.
4
3
1
Make sure arcs
are aligned.
15
Publicidad
