Velleman CAMSET23 Manual Del Usuario página 4

• Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
Features
4.
• compact 3.5" high-resolution TFT screen
• camera with IR LEDs
• camera set comes with installation material included:
o different mounting nuts for the camera
o drill for installing the camera in a bumper
5. Installation
Refer to the illustrations on page 2 of this manual.
• Make sure the vehicles' engine is off and power is removed from the
electrical system. Disconnect the battery and remove the ignition key
from the ignition switch.
• Mount the LCD [A] with the mounting bracket [B] on the dashboard
using the double sided tape on the bottom of the bracket. Make sure the
driver has a clear view on the monitor.
• Guide the video cable [C] to the back of the car where the camera will be
mounted.
• Drill a hole in the bumper using the included drill.
• Insert the cables [5, 6] and the camera [G] into the hole. Depending on
the location of the camera, use the adjustment rings to level the camera
with the surface of the bumper. Use the nut to secure the camera. Do not
tighten it yet.
• Connect the video cable [C] to the camera [5, yellow]; connect the
other end to the monitor [1, yellow].
• Connect the red wire [3] of power cable 1 [D] to the cars +12V electrical
circuit, at a location where there is only power once the ignition key is
turned (run circuit).
• Connect the black wire [4] of power cable 1 [D] to ground (GND).
• Connect the other end of power cable 1 [D] to the monitor [2, black].
• Connect the red wire [3] of power cable 2 [E] to the reverse light circuit
(+12V).
• Connect the black wire [4] of power cable 2 [E] to ground (GND).
• Connect the other end of power cable 2 [E] to the camera [6, black].
• Restore power to the vehicles' electrical system; insert the ignition key in
the ignition switch and turn.
• The monitor will now show the image of the camera. Verify that this
image is upright. If not rotate the camera until it is, than secure it by
tightening the nut [F].
27/04/2009
CAMSET23
4
®
©2008 Velleman Components nv