Publicidad
Idiomas disponibles
Idiomas disponibles
If you do not install this anti-topple device the fireplace
could tip and cause damage or injury
This product is not a substitute for parental supervision. Real Flame® assumes
!
CAUTION
no responsibility or liability for improper installation or excessive loads
placed on any of the supplied components.
Maximum weight for the anti-topple device is 40 lbs.
L
Long Wood Screw
2x
O
1x
Note: Your mantel may vary slightly from the one depicted in this illustration.
1
With a pencil, make a mark 3 inches
below the mantel top to mark the
correct mounting height of the
L-Bracket (O).
3"
3
Locate the threaded
insert under mantel top
and use 1 Small Screw
(N) to anchor one end
of the Cable (P).
Real Flame® Customer Service: 1-800-654-1704
Anti-Topple Device
Installation
Anti-Topple Device
M
2x
P
L-Bracket
1x
N
P
1x
1x
-10032
N
Drywall Anchor
Cable
2
Locate a stud. Anchor the
L-Bracket (O) to the wall using
two Long Wood Screws (L). If a
stud is unavailable, use the
included Drywall Anchors (M).
Studs
4
Secure the other end of the Cable (P)
to the L-Bracket (O) using the remaining
Small Screw (N).
N
1x
10
Short Screw
2x
L
O
2x
1x
Publicidad
