Publicidad
Idiomas disponibles
Idiomas disponibles
4. Release the side locking covers to
detach the water tank cover.
5. The drip tray must be placed.Then
gently press the valve lever to serve your
drinks.
2
1
3.6.2 Filling the Water Tank
• Remove the top cover of the water tank.
• Fill the tank up with water.
• Mount the top cover back on the water
tank.
Important: Do not use the water
dispenser for anything except water.
Important: If you leave water in the
tank for a long time, it will cause an
odour. In this case, clean the tank and keep
using it.
Important: Clean the water tank
before using it for the first time.
3.6.3 Cleaning the Water Tank
• Lift the water tank.
• Remove the tank cover by releasing the
side locking covers.
• Clean the tank with warm water and
reassemble the pieces that you have
removed.
3.6.4 Stowing the Water Tank
• Install the water tank as shown.
• Make sure that the tap and the hole
• Water flow may not be as expected if
Drip Tray
Please pay attention in order not to go
down min level on the tank surface. During
the usage of dispenser the water can be
splash after min water level.
If drip tray is completely filled with
water, it should be cleaned in order to
prevent overflowing.
3
EN - 42
match each other while installing.
the tank has not been installed properly.
Also check that the gaskets have been
assembled properly.
Please hold the glass momentarily
after distribution to avoid drips.
Publicidad
