Descargar Imprimir esta página

Sunex Tools 6603ASJPK Manual Del Propietário página 3

Ocultar thumbs Ver también para 6603ASJPK:

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING INFORMATION - JACK STANDS
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING PROCEDURES,
SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of the
device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost or not
legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to and
discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only by the
exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and operation
of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use. Examples of
hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading, off-centered loads, use on
other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• Inspect the jack stands before each use. Do not use jack stands if damaged, altered, modified, in poor condition, or unstable due to
loose or missing components. Make corrections before using.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users and bystanders).
• Do not use jack stands beyond the pair's rated capacity. Do not shock Load.
• Do not crawl under the vehicle while lifting vehicle or placing or removing the jack stands.
• Use as a matched pair only.
• Maximum load capacity per matched pair shall not exceed the rated capacity of the individual stand.
• Use only on a hard level surface capable of supporting the load.
• Stands are to be used in matched pairs to support one end of a vehicle only. Do not simultaneously support both ends or one side
of a vehicle.
• Apply the emergency brake and put the gear shift lever in park or in gear if a manual shift transmission, and chock the tires that will
not be lifted off the ground.
• Ensure both stands are set at same height and locking pins are fully engaged.
• Check the stands for solid contact with the ground and vehicle.
• Never use the stand's lower support plate (if so equipped) as a load bearing surface for the locking pin.
• Consult the vehicle manufacturer for the proper frame support locations.
• Center load on saddle. Do not use saddle lugs to support the load.
• Make sure the stand's locking pins are fully engaging the stand on both sides and the support column saddle is making contact
with a vehicle support surface that can support the load.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the
manufacturer's authorized representative.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
6603ASJPK
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
3
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
Rev. 2/6/17

Publicidad

loading