Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Using the short hose as an extension
30
English
Untitled-1 30
B
A
C
1. Close the cold water tap. If you have a
washer's cold water hose attached to
the cold water tap, unscrew and remove
the hose. Then, connect the short hose
(B) to the cold water tap. Turn the
coupling by hand until it is tight.
2. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
3. Connect the Y-connector (A) to the
brass male end of the short hose. Turn
the coupling by hand until it is tight.
4. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
5. Connect the angled end of the water
hoses (C) to the filling valve at the
bottom rear of the dryer. Turn the
coupling by hand until it is tight.
6. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
7. If you detached the cold water hose
from your washer, attach the hose to
the free end of the Y-connector, tighten
the coupling by hand until it is tight,
and then, using a pliers, tighten an
additional two-thirds turn.
8. Open the cold water tap, and then check
for any leaks.
7/8/2019 5:01:41 PM
Publicidad
