Descargar Imprimir esta página

Cub Cadet BV228 Manual Del Operador página 17

Ocultar thumbs Ver también para BV228:

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparing the Unit for Use after Long-term Storage
1. Remove the spark plug. Tip the unit and drain all of the oil from
the cylinder into an approved container. Reinstall the spark plug.
NOTE: Do not use fuel that has been stored for more than 30 days.
Dispose of old fuel and oil according to federal, state and local
regulations.
PROBLEM
THE ENGINE WILL NOT START
The fuel tank is empty
The primer bulb was not pressed enough
The engine is flooded
The fuel is old (over 30 days) and/or improperly mixed
The spark plug is fouled
THE ENGINE WILL NOT IDLE
The air filter is dirty
The fuel is old (over 30 days) and/or improperly mixed
The idle speed is incorrect
THE ENGINE WILL NOT ACCELERATE
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
THE ENGINE LACKS POWER OR STALLS
The fuel is old (over 30 days) and/or improperly mixed
The air filter is dirty
The spark plug is fouled
TROUBLESHOOTING
If further assistance is required, contact an authorized service dealer.
SOLUTION
Fill the fuel tank with properly-mixed fuel
Press the primer bulb 10 times or until fuel is visible
Move the choke lever to Position 3, squeeze the throttle control and
pull the starter rope
Drain the fuel tank and add fresh, properly-mixed fuel
Replace the spark plug
Clean or replace the air filter
Drain the fuel tank and add fresh, properly-mixed fuel
Adjust the idle speed
Drain the fuel tank and add fresh, properly-mixed fuel
Clean or replace the air filter
Drain the fuel tank and add fresh, properly-mixed fuel
Clean or replace the air filter
Replace the spark plug
17

Publicidad

loading