Publicidad
Idiomas disponibles
Idiomas disponibles
How To Synchronize Left Burners
■ M ake sure the pan rests flat on the glass cooktop.
Choose pans that match the circle/bridge area as
closely as possible.
■ T o use both left elements at the same setting, push
and turn the control knob to
desired settings. It is normal to hear a clicking noise
when the elements are in sync mode.
■ T o use the left front surface element only, push and
turn the control knob to
desired settings.
Content just for the following models: CP9530, CP9536
and JP7030, JP7036 – Backlit Knobs.
When using Sync Burner the left rear knob lighting will
slightly flicker. The rear element is controlled by the front
element and briefly lights the knob as the two elements
heat. This is normal.
Selecting Cooktop Settings
Choose the element/burner that is the best fit to the
cookware size. Each element/burner on your new
cooktop has its own power levels ranging from low to
high. Power level settings necessary for cooking will vary
depending on the cookware being used, the type and
quantity of food, and the desired outcome.
In general:
■ U se lower settings for melting, holding, and
simmering.
■ U se higher settings for heating quickly, searing, and
frying.
■ F or "Warming Zone" elements intended for holding
(some models), use the Med-Hi settings.
When keeping foods warm confirm selected setting is
sufficient to maintain food temperature above 140°F.
Larger elements are not recommended for melting.
Power boil elements are best suited for boiling water,
particularly with pots that are 9" or larger.
49-2000975 Rev. 1
, stopping at the
, stopping at the
Hi
boiling quickly
frying
searing
reducing
simmering
holding
Low
melting
13
Publicidad
