Publicidad
Idiomas disponibles
Idiomas disponibles
6
RACK ASSEMBLY - WIND DEFLECTOR
NOTE : The Wind Deflector must be fitted to the underside of the front Combined Slat.
If you are going to put a Leg or Foot on the Combined Slat (Recommended), you will need to slide the M8 Bolt
used for attaching these into the Machined Slots before assembling the Wind Deflector.
6.1
6.2
6.3
RRSTUNI_REV_A05
5
4
2
5
4
3
2
9MM
Ensure that your Slimline II Tray is upside
down. Check by looking at the product
sticker. It should be upside down as shown.
Insert two Button Head Bolts, M8 Half Nuts
and Schnorr Washers (Items 2, 4 & 5)
assemblies into the Combined Slat
as shown. Slide them to the center of the
Combined Slat making sure that the
Schnorr Washer is above the T-slot Channel.
Assemble Items 2, 4 & 5 to both LH & RH
Wind Deflectors (Item 3) as shown.
7
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
Publicidad
