Panasonic WH-SXC09D3E8-1 Instrucciones De Operación página 8

WEEKLY TIMER SETTING
Indicates the selected day
Lights up if Timer operation is selected
6 different programs can be set in a day (1 ~ 6)
TIMER
MONTUEWEDTHU FRI SAT SUN
ON
OFF
Water temperature thermo shift (-5ºC ~ 5ºC)
OFF Timer - To automatically switch "OFF" the unit
ON Timer - To automatically switch "ON" the unit
Day to be selected
Function
Enter timer mode
Set day & time
Add/Modify timer
Disable timer
Enable timer
Check timer
Cancel timer
Notes:
• You can set the Timer for each day of the week (Monday to Sunday) with 6 programs per day.
• When the unit is switched on by the ON TIMER, it will use the previously set temperature to control the water outlet
temperature.
• Same timer program cannot be set in the same day.
• You may also select collective days with same timer setting.
8
• Promotes energy saving by allowing you to set up to 6 programs in any given day.
1 2 3 4 5 6
SOLAR REMOTE
Step
TIMER
Press .
1. Press or to select your desired day.
SELECT
2. Press to confi rm.
3. "1" will be blinking, press
OFF/ON
4. Press to select ON or OFF timer.
5. Press or to select your desired time.
MODE QUIET
You can set , ,
SET
6. Press to confi rm program 1. The selected day will be highlighted with ▼.
• After 2 seconds, the display will move to the next program.
7. Repeat steps 4 to 7 to set programs 2 to 6.
• During timer setup, if no button is pressed within 30 seconds, or if the
setting at that moment is confi rmed and timer setup is ended.
Repeat the steps above.
CANCEL
TIMER
Press , then press
SET
TIMER
Press , then press
TIMER
1. Press .
2. Press or until your desired day is shown, press
3. Press or to check the set programs.
TIMER
1. Press .
2. Press or until your desired day is shown, press
SELECT
3. Press to enter program setting.
4. Press or until your desired program is shown.
CANCEL
5. Press to cancel the program.
TIMER
C
OFF/ON
CLOCK
SELECT
to set program 1.
HEATER
and desired shift temperature
.
.
SETTING STATUS
SET
MODE
SELECT QUIET HEATER
CANCEL
with timer.
SET
button is pressed the
SELECT
to confi rm your selection.
SELECT
to confi rm your selection.