Publicidad
Idiomas disponibles
Idiomas disponibles
• A strain relief must be used. Do not loosen the nuts already installed on the terminal
block. Be sure they are tight. Use a
• Since january 1, 1996, The national electric code requires that new wiring (not existing)
utilize a 4-wire connection to this dryer.
STEP 4 Level the dryer
To ensure optimal performance, the dryer must be level.
A
DV3200T_DC68-03784N-03_EN.indd 27
/
" (1 cm) deep well socket.
3
8
1. Using a level (A), check if the dryer
is level side to side and then front to
back. If the dryer is not level, adjust the
A
leveling feet (B) at the bottom of the
dryer. Then, check if the dryer is level
again.
B
• To set the dryer to the same height
B
• Adjust the leveling feet only as much
NOTE
as your washer, fully retract (A)
the leveling feet by turning them
counterclockwise, then loosen (B) the
feet by turning them clockwise. Once
the dryer is the same height as the
washer, follow the directions above
to level the dryer.
as necessary to level the dryer.
Extending the leveling feet more
than necessary can cause the dryer
to vibrate.
English 27
2020-12-07
10:51:24
Publicidad
