Publicidad
Idiomas disponibles
Idiomas disponibles
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
Figure 1
2. Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#7) as shown in Figure 2.
a) If necessary loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support
Plate (#43) and Caster Beam (#7) as shown in the Top View and Figure 2.
b) Slide one Hex Bolt (#27) through one linkage (#16) one Spacer (#36) pass through Caster Beam
(#7), followed by one Plastic Washer (#39), Strut Tube (#17), another Plastic Washer (#39), inner
Support Plate (#43) and Lock Nut (#28).
c) Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d) Tighten Bolts (#13) and Nuts (#28) securely.
e) Tighten Nuts (#28) on Bolts (#27) securely.
NOTE: Tighten nuts so that end of Bolt (#27) in even with the edge of nut.
Note: Linkages & Strut
tubes must be turned as
shown or table will not
operate correctly.
7
Figure 2
27
31
7
32
16
39
43
28
13
36
1. Attach Wood Bottom Board (#15) to Caster Beam
Assemblies (#7) as shown in Figure 1. Turn
Caster Beams as shown and attach board with four
Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Thumb Screws securely.
Note: Support Plate (#43)
must be on inside of Caster
Rail (#7) as shown.
43
15
17
7
3
31
7
32
Top View
28
43
(Inner Plate)
28
39
12
13
7
36
27
17
16
Publicidad
