Bosch GWS18V-10 Instrucciones De Funcionamiento Y Seguridad página 12

2610068708 11-21 GWS18V-10.qxp_GWS 11/17/21 12:41 PM Page 12
Kickback Control:
The electronics in the power tool detects
situations where the wheel or accessory may
be at risk to bind. The electronics prevents
further rotation of the drive spindle by
switching the power tool off (it does not
prevent kickback). To resume operation, turn
on/off switch to the off position, then restart
tool.
Constant Response Circuitry:
Helps maintain near constant RPMs between
no-load and load conditions.
Automatic Restart Protection:
Helps to prevent accidental startups after
power has been interrupted, e.g. the battery
was removed from the tool with the switch
locked in the ON position. To resume
operation, turn the switch to the OFF
position, and then back to the ON position to
restart the tool.
complete stop before setting the tool
down. The brake action of this grinder is
not intended as a safety feature. Using the
appropriate guard when operating the
grinder is your best protection against
unintentional contact with a spinning
accessory. Unintended contact with a
rotating accessory can cause property
damage and\or personal injury.
electric braking action is initiated ONLY by
the release of the trigger switch and in a
tool that has power available. When
electrical power is lost due to a discharged
battery or other causes, the electric brake
will not operate and the motor will
gradually slow down. Unexpected run down
time may cause property damage and/or
personal injury.
Functional Descriptions
Brake Operation
Let the grinder
accessory come to a
Know the charge state of
your battery. The
Overload Protection:
Helps protect tool from excessive heat that
may damage motor. If tool stops or slows
during operation, allow motor to cool for 30
seconds by running no-load. If the overload
protection stops the tool repeatedly,
excessive force is causing the tool to
overload. Stop excessive force and readjust
work piece to reduce force applied.
Drop Control:
This grinder is equipped with sensors that
detect impact to the grinder. The grinder
will turn off if it is dropped on most hard
surfaces from height greater than one foot,
or hit with force approximately equivalent
to more than a one foot drop. After any
impact or activation of the shut off feature,
always inspect the grinder and the battery
for signs of damage and do not use the
grinder or the battery if any damage is
suspected.
Your grinder is equipped with an automatic
electric brake which is designed to rapidly
stop the accessory from spinning after you
release the trigger switch. This feature
helps improve jobsite productivity.
Braking starts once the power is turned off.
The brake requires a charged battery to
function. Stopping time will vary depending
on, among other factors, accessory used,
and number of actuations. The electric
brake of your grinder has been designed for
a high degree of reliability, but unexpected
circumstances such as contamination or
failure of the motor's components can
cause the brake to not activate. If the tool
operates but the
consistently stop the accessory, DO NOT
use the grinder and have it serviced by a
Bosch Factory Service Center or Bosch
authorized service facility.
-12-
brake does not