Bosch GWS18V-10 Instrucciones De Funcionamiento Y Seguridad página 14

2610068708 11-21 GWS18V-10.qxp_GWS 11/17/21 12:41 PM Page 14
Vibration Control Side
Handle
The side handle is used to control and
balance the tool. The handle must be thread -
ed into the front housing on either side of the
tool, depending on per sonal preference and
comfort. Use the side handle for safe control
and ease of operation (Fig. 1).
Quick-Clamping Nut
Use the quick-clamping nut to secure the
grinding/cutting disc without the need for
additional tools. Only use the quick-clamping
nut for grinding/cutting discs up to a
maximum diameter of 6".
• The quick-clamping nut may be used only
for grinding or cutting discs.
• Only use quick-clamping nuts that are in
good working order and not damaged.
• When screwing on, make sure that the
printed side of the quick-clamping nut is
not facing the grinding disc.
Press the spindle lock
button to lock the
grinding spindle. To
tighten the quick-
clamping nut, lift the
fold-up bar and turn
the quick-clamping
nut firmly clockwise.
Then push down the
fold-up bar to secure
the quick-clamping
nut. It is not sufficient
to tighten the disc
along the edge.
Assembly
Hand Shield
(sold separately)
The hand guard is to be used with backing
pads, sanding discs and wire brushes to keep
fingers and hand away from work surface,
sharp edges, burrs and debris. When using
the optional hand guard accessory insert side
handle through hole in guard and then thread
into housing (Fig. 1).
Ensure that hand guard is positioned
between hand and backing pad, sanding disc
or wire brush.
A properly secured,
undamaged
clamping nut can be
removed by hand. To
do this, lift the fold-up
bar and turn the
quick-clamping nut
firmly anticlockwise,
Fig 8. If the quick-
clamping nut is stuck,
do not attempt to
loosen it with a tool –
always use a two pin
spanner.
Operating Speed rated at least equal to the
maximum speed marked on the power tool.
This speed is based on the strength of the
wheel. It is not meant to imply a best or most
efficient operating speed. Do not exceed the
Maximum Safe Operating Speed.
-14-
quick-
Only use accessories
with Maximum Safe