Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
DOOR REVERSAL INSTRUCTIONS
If you fi nd the direction of opening the door on your appliance inconvenient, you can change it by following the steps
shown in the diagrams.
1. Remove the three (3) screws from the back of the worktop, lift the back of the worktop slightly and pull the worktop
forward, this will remove the worktop. See Figure 1.
2. Remove the left or right door strip cover (depending on which side you are moving the door to) and the left or right
hinge cover, then remove the two (2) upper hinge screws and remove the upper hinge. Remove the hinge pin from the
door, move it to the other side of the door. See Figure 2.
3. Loosen the upper door spindle and remove the door assembly. See Figure 2.
4. Install the upper door spindle to the opposite side of the upper hinge, place the upper hinge onto the other side of the
cabinet, install the door strip cover and the hinge cover to the opposite side of where you removed it. See Figure 4.
5. Loosen the adjustable foot and remove the two (2) screws around it. Remove the two (2) bottom hinge screws, re-
move the bottom hinge. Reinstall the foot and two (2) screws where the bottom hinge used to be. Install the bottom
hinge where the foot used to be. See Figure 5.
6. Make necessary adjustments to the upper hinge and bottom hinge, reinstall the worktop in reverse order of removing
it.
INTERIOR LIGHT (SOME MODELS ONLY)
When the door is open, the LED light turns on. When the door is closed, the LED light turns off. In the event that your
LED light burns out, please contact a Danby certifi ed service technician. Please note, the functionality of the unit is not
affected if the light has burned out.
To avoid personal injury to yourself and/or property, we recom-
mend someone assist you during the door reversal process.
CAUTION
6
Publicidad
