Lenco SCD-720SI Manual De Usuario página 13

Scan Setting
1. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
2. Press the or
3. Press the or
"Strong" is selected, only the strong stations are detected. Scanning will ignore the noisy stations. When "All" is selected,
all stations will be detected during FM scanning even if the radio station is a bit noisy.
4. The next time doing a FM scan the unit will search for the stations based on this confirmed setting.
Audio Setting
1. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
2. Press the or
3. Press the or
Loading and Playing CD Disc
Open the CD door. Install a disc with the CD label side facing up. Close the CD door. Press the SOURCE button to CD mode.
After reading, the total number of tracks will be shown on the display and it will automatically start to play.
Reading and Playing USB Device
Insert a USB device into the USB input jack. Press the SOURCE button to USB mode. After reading the total number of tracks
will be shown on the display. It will automatically start to play.
Play/Pause Control
To pause playback press the
Stop Control
To stop playback press the
Skip Track
During playback press the
High Speed Music Search
During playback press & hold the
When you release the
Repeat Play / Random Play
CD Disc mode
During playback press the REPEAT button once, the display shows "REP.ONE". The current track will be played repeatedly.
When pressing the REPEAT button again, the display shows "REP.ALL". All tracks will be played repeatedly.
When pressing the REPEAT button again, the display shows "RANDOM". All tracks will be played in random sequence.
When pressing the REPEAT button again, the unit will resume to normal playback.
MP3 Disc or MP3 USB mode
During playback press the REPEAT button once, the display shows "REP.ONE". The current track will be played repeatedly.
When pressing the REPEAT button again, the display shows "REP.ALBUM". All tracks in the current folder will be played
repeatedly.
When pressing the REPEAT button again, the display shows "REP.ALL". All tracks will be played repeatedly.
When pressing the REPEAT button again, the display shows "RANDOM". All tracks will be played in random sequence.
When pressing the REPEAT button again, the unit will resume to normal playback.
Programmed Playback
CD Disc mode
This unit can be programmed to play a sequence of tracks selected.
1. In stop mode press the PROGRAM button, the display shows the program number and the track number.
2. Press the or
3. Press the PROGRAM button to save the desired track.
4. Repeat steps 2-3 to store up to 30 programmed tracks.
5. Press the button to start playing the programmed tracks.
6. To clear the program play, press the
7. During program play you can also do the "Repeat One" or "Repeat All" operation, however the random play is not
supported.
button until "Scan" is displayed and then press the ENTER button.
button to toggle between "Strong" and "All" and then press the ENTER button confirm. When the
button until "Audio" is displayed and then press the ENTER button.
button to toggle between "Stereo" or "Mono" selection and then press the ENTER button confirm.
CD/USB OPERATION
button. Press the button again to resume playback.
button.
or button to skip to the previous or next track.
or button to start high speed searching.
or button normal speed playback will resume.
button to select the desired track.
button twice or change to another mode.
-13-