Perel Tools EWL19 Manual Del Usuario página 3

Idiomas disponibles

5. Replacing the light bulb

• To install/replace the lamp, first unplug the device from the mains outlet.

• Be aware that the housing might become hot during operation – allow enough time for the device

to cool down before touching it.

• Open the front cover by loosing the 4 screws.

• DO NOT TOUCH the bulb with bare fingers – use a piece of cloth or wear gloves.

• Only use bulbs that are suited for this device. Refer to the "Technical Specifications"

below.

• After replacing the bulb, close the front cover firmly with the 4 screws. Make sure that the seal

between cover and housing is still intact and positioned correctly.

• Re-apply mains power to the device.

6. Technical specifications

power supply

power consumption

luminance

cable length

height

weight

Use this device with original accessories only. Velleman nv cannot be held responsible in

the event of damage or injury resulted from (incorrect) use of this device. For more info

concerning this product, please visit our website www.perel.eu. The information in this

manual is subject to change without prior notice.

This manual is copyrighted. The copyright to this manual is owned by Velleman nv. All

worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced

to any electronic medium or otherwise without the prior written consent of the copyright holder.

23/11/2009

EWL18/EWL19

EWL18

230VAC / 50Hz

300mA / 32-36W

2200 lux

90-165cm

3500g

EWL19

600mA / 64-72W

4400 lux

4800g

Ewl18