Publicidad
Idiomas disponibles
Idiomas disponibles
⚫
Devices with class 1 construction should be connected to a
main socket outlet with a protective earthed connection.
⚫
Devices with class 2 construction do not require a earthed
connection.
⚫
Always hold the plug when pulling it out of the main supply
socket. Do not pull the power cord. This can cause a short
circuit.
⚫
Do not use a damaged power cord or plug or a loose outlet.
Doing so may result in fire or electric shock.
29.
If the product contains or is delivered with a remote control
containing coin/cell batteries:
Warning:
⚫
"Do not ingest battery, Chemical Burn Hazard" or
equivalent working.
⚫
[The remote control supplied with] This product contains a
coin/button cell battery. If the battery is swallowed, it can
cause severe internal burns in just 2 hours and can lead to
death.
⚫
Keep new and used batteries away from children.
⚫
If the battery compartment does not close securely, stop
using the product and keep it away from children.
⚫
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical
attention.
30.
Caution about the use of Batteries:
⚫
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
⚫
Battery cannot be subjected to high or
lowextremetemperatures, low air pressure at high altitude
during use, storage or transportation.
⚫
Replacement of a battery with an incorrect type that can
result in an explosion or the leakage of flammable liquid or
gas.
⚫
Disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an
explosion.
⚫
Leaving a battery in an extremely high temperature
surrounding environment that can result in an explosion or
that leakage of flammable liquid or gas.
⚫
A battery subjected to extremely low air pressure that may
result in an explosion or the leakage of flammable liquid or
gas.
⚫
Attention should be drawn to the environmental aspects of
battery disposal.
INSTALLATION
•
Unpack all parts and remove protective material.
•
Do not connect the unit to the mains before checking the mains
voltage and before all other connections have been made.
5
Publicidad
