Perel PTC0003 Manual Del Usuario página 6

5. Overview
Refer to the illustrations on page 2 of this manual.
1
2
6. Installation
The heater shall be used as a portable appliance only. Install vertically on a flat, dry,
stable and non-slippery surface.
7. Operation
7.1 General Operation
Insert the power plug into the mains.
Turn the thermostat knob fully to the right.
Switch on the heater by selecting the power (I = 1000 W/II = 2000 W).
To distribute the heat more quickly, switch on the fan (
without heating to blow cold air.
Switch on/off the oscillating function with the oscillation switch at the back.
When the room has reached the desired temperature, turn the thermostat knob to the
left until the heater switches off. The temperature is now set and the heater will
automatically switch on/off to keep the temperature at a constant level.
Switch off and disconnect the heater after use.
This appliance is equipped with a tilting protection, which automatically switches off the
heater when it is pushed over. To restore the heater, re-install in the proper vertical
position.
7.2 Overheating Protection
This heater is equipped with an overheating protection, which will automatically switch
off the heater in case of overheating. If this occurs, please unplug from the mains and
allow cooling for 30 minutes before re-connecting and switching on again.
To avoid overheating, check that the appliance is sufficiently ventilated and that the air
intakes are unobstructed. Please contact your local dealer if the heater keeps switching
off.
V. 04 – 24/02/2022
thermostat knob
heat setting button
PTC0003
3
6
oscillation switch
). You can also use the fan
©Velleman Group nv