Stiga Force T8630 Manual Del Usuario página 2

For aid in identifying hardware, see hardware identifier on pg 13.
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2. Align U-Support (#7) and U-Leg (#2) on Table
Top as shown in Figure 1.
Note: "U-Leg" (#2) is larger and
Wider than the "U-Support" (#7).
The U-Leg should be installed on
the end of the table half with the
end rail mounting holes.
3. Put plastic caps (#13) on the end of
U-Leg (#2). See Figure 1.
13
Note: Indentations are
small so look closely.
(U-Leg)
2
7
(U-Support)
2
End Rail Mounting
Indentations
Figure 3
Figure 3
1
Figure 1