Descargar Imprimir esta página

Braun 8390CC Manual De Instrucciones página 16

Ocultar thumbs Ver también para 8390CC:

Publicidad

Idiomas disponibles

Idiomas disponibles

Shaver does not
charge
completely and
keeps blinking.
Unpleasant
smell from the
shaver head.
Battery
performance
dropped
significantly.
Shaving
performance
dropped
significantly.
Shaver head is
damp.
Clean & Charge Station
Cleaning does
not start when
pressing the
start button.
Increased
consumption of
cleaning fluid.
Ambient temperature is out of
valid range.
1. Shaver head is cleaned
with water.
2. Cleaning cartridge is in use
for more than 8 weeks.
1. Foil and cutter are worn
which requires more power
for each shave.
2. Shaver head is regularly
cleaned with water but not
lubricated.
1. Foil and cutter are worn.
2. Shaving system is
clogged.
1. Drying time after automatic
cleaning was too short.
2. Drain of the Clean & Charge
station is clogged.
1. Shaver is not placed
properly in the Clean &
Charge Station.
2. Cleaning cartridge does
not contain sufficient
cleaning fluid (display
blinks red).
3. Appliance is in stand-by
mode.
Drain of the Clean &
Charge station is clogged.
Recommended ambient temperature
for charging is 41 °F to 95 °F / 5 °C to
35 °C.
1. When cleaning the shaver head with
water only use hot water and from
time to time some liquid soap
(without abrasive substances).
Remove Foil & Cutter cassette to let
it dry.
2. Change cleaning cartridge at least
every 8 weeks.
1. Renew Foil & Cutter cassette.
2. If the shaver is regularly cleaned
with water, apply a drop of light
machine oil on top of the foil once a
week for lubrication.
1. Renew Foil & Cutter cassette.
2. Soak the Foil & Cutter cassette into
hot water with a drop of dish liquid.
Afterwards rinse it properly and tap
it out. Once dry apply a drop of light
machine oil on the foil.
1. Clean directly after shaving to allow
enough time for drying.
2. Clean the drain with a wooden
toothpick.
1. Insert shaver into the Clean &
Charge Station and push it to the
rear side of the station (contacts of
the shaver need to align with
contacts in the station).
2. Insert new cleaning cartridge.
Press the start button again.
3. Press the start button again.
– Clean the drain with a wooden
toothpick.
– Regularly wipe the tub clean.
15

Publicidad

loading

Este manual también es adecuado para:

8 serie5795