Descargar Imprimir esta página

Danby DFF110A1WDBL1 Manual Del Propietário página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 60.8 cm (24 inches) wide
by 149.3 cm (58.8 inches) high by 66.2 cm
(26.1 inches) deep. Make sure that you leave
the minimum amount of space between the
appliance and all surrounding walls and vents.
Do not cover any of the ventilation openings
with any material as the appliance needs
adequate space to breathe.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
OPERATING INSTRUCTIONS
FEATURES
1. Freezer Section
2. Thermostat Dial
3. Wire Shelves
4. Crisper
5. Magnetic Gasket
6. Bottle Storage
7. Adjustable Feet
5
6
LEVELING INSTRUCTIONS
There are two adjustable feet on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the leveling feet counter-clockwise as far as
they will go, until the top of the foot is touching
the bottom of the chassis.
2. Slowly turn the leveling legs clockwise until the
appliance is level.
3
1
2
3
4
7

Publicidad

loading