Danby DFF110A1WDBL1 Manual Del Propietário página 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove both leveling feet from the bottom of
the appliance. Remove the screws securing
the lower hinge and remove the lower hinge.
Remove the refrigerator door from the cabinet.
See fi gure A.
2. Remove the center hinge from the middle of the
cabinet. Remove the freezer door. Remove the
hole covers from the left side of the cabinet and
install them in the hinge holes on the right side
of the cabinet. See fi gure B.
3. Remove the hinge pin by unscrewing it from the
worktop. Install the hinge pin in the pre-drilled
hole on the left side of the worktop. Remove the
hole cover from the top left side of the freezer
door and install it in the hinge hole on the top
right side of the freezer door. See fi gure C.
4. Reinstall the freezer door and the center
hinge. The center hinge will need to be fl ipped
180° from its original position before being
reinstalled. Reinstall the refrigerator door and
the lower hinge. Reinstall both adjustable feet.
Note: When installing the doors, ensure that the
doors are level. If the doors are not level, the rubber
gaskets will not make a good seal with the cabinet
which can cause the appliance to malfunction.
A
B
C
5