Publicidad
Idiomas disponibles
Idiomas disponibles
Operations
Auto dispense
Dosage level setting
Press Detergent or Softener to select the desired dosage level.
• You can select from
Concentration level setting
1. Press and hold Detergent or Softener for 3 seconds to enter the concentration level
setting.
2. Press Detergent or Softener to select the desired concentration level.
- You can select from
3. When complete, press and hold Detergent or Softener for 3 seconds to confirm your
changes.
NOTE
• If the Softener or Detergent button's LED blinks, refill the corresponding compartment.
• To determine your water hardness, contact your local water municipality provider. For
well water, conduct a water hardness test.
English
52
Untitled-3 52
Untitled-3 52
The LEDs on the Detergent and Softener
buttons indicate whether the auto
dispense system is on or off. If the LED on
the button is off, press the button to turn
on the dispenser system by setting the
dosage level. You can also use the buttons
to set the concentration level of detergent
and softener. Refer to the following
instructions to set the dosage level and the
concentration level.
The Auto Dispense System does not work
if the LEDs on the buttons are off.
(Less),
(Standard), or
(Normal),
(x2), or
(More),
(Off).
(x3).
2021-07-14
2021-07-14
12:20:15
12:20:15
Publicidad
