7. The wheel continues to rotate after the tool is switched off .
After switching off the machine, do not put it down until the
depressed center wheel has come to a complete stop. Apart
from avoiding serious accidents, this precaution will reduce
the amount of dust and swarf sucked into the machine.
8. When the machine is not use, the power source should
be disconnected.
9. Be sure to switch OFF and disconnect the attachment plug
from the receptacle to avoid a serious accident before the
depressed center wheel is assembling and disassembling.
10. RCD
The use of a residual current device with a rated residual
current of 30 mA or less at all times is recommended.
NAMES OF PARTS (Fig. 1 – Fig. 8)
Wheel guard
Toolless wheel guard
Hex. bar wrench
M5 hex. socket bolt
Lever
Push button
Spindle
Wheel washer
Depressed center
wheel
(sold separately)
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
G23STA / G23SWA / G23SWUA / G23SCA :
Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment and
its implementation in accordance with national law,
electric tools that have reached the end of their life
must be collected separately and returned to an
environmentally compatible recycling facility.
V
Rated voltage
Alternating current
Power input
P
n
Rated speed
min
Revolution or reciprocations per minute
-1
Wheel nut
"Quick" clamping nut
Wrench
Wheel guard with side
guard
(sold separately)
Abrasive cutting wheel
(sold separately)
Lock lever
Trigger switch
Diamond wheel
(sold separately)
9
D
Wheel outer diameter
d
Wheel hole diameter
t
Wheel thickness
Peripheral speed
Weight (Only main body)
kg
Switching ON
Switching OFF
Lock
Switch locks to the "ON" position.
Soft-start (For G23SWUA / G23SCA only)
Usual carbon brush
U
Auto-stop carbon brush
A
Disconnect mains plug from electrical outlet
Warning
Class II tool
STANDARD ACCESSORIES
In addition to the main unit (1), the package contains
the accessories listed in the below.
(1) Wrench .........................................................................1
(2) Side handle ...................................................................1
(3) Hexagonal bar wrench ..................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
○ Removal of casting fi n and fi nishing of various types of
steel, bronze and aluminum materials and castings.
○ Grinding of welded sections or sections cut by means of
a cutting torch.
○ Grinding of synthetic resins, slate, brick, marble, etc.
○ Cutting of synthetic concrete, stone, brick, marble, and
similar materials.
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 145.
(For G23SWUA / G23SCA only)
○ Soft-start
○ 0 Voltage Re-start Protection
The 0 voltage restart protection feature prevents the
power tool from restarting after the power has been
temporarily cut off during operation.
* Be sure to check the nameplate on product as it is subject
to change by areas.
English