Publicidad
Idiomas disponibles
Idiomas disponibles
16. Place Leg Assembly (from previous step) on table top. Be sure that
the offset holes in (#19) legs are closest to the table. See
Figure 9 & Detail H.
17. Attach leg Assembly (from previous step) to Bracket (#20) with Hex
Bolt (#24), Plastic Washer (#38) and Locknut (#34) as shown in
Detail I & Detail J. Tighten the Locknuts (#34) all the way but be
careful not to over tighten as you could bend the Leg (#19).
NOTE:
Prepare an area for the assembly of the second table top half. If
necessary, move the first table top half aside with the aid of a helper. Be sure
to place it in a location where it won't be disturbed or damaged. If setting on
its side, be sure to place the bottom edge no less than 12 inches away form
the wall. Also be sure to place carpet or pieces of the shipping carton down to
protect table top edges. If floor is not carpeted, brace table top half with a
heavy object to keep it from sliding.
18. Repeat steps 10 through 17 to complete second Table Top Assembly.
shorter distance
Closest to the table
Detail H
19
Figure 9
Bolt (#24) goes in
the top hole of
Bracket (#20)
24
20
Detail I
9
34
38
24
19
20
Detail J
Publicidad
