Descargar Imprimir esta página

Whirlpool WHAD703PAW Guía De Uso Y Cuidado página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

Bucket Full Indicator
When the water bucket is full of water, the unit will
automatically shut off, make a beeping noise, and the
Bucket Full Indicator will light up. See the "Emptying
the Water Bucket" section for more information.
Clean Filter Indicator
After 250 hours of use, the Clean Filter indicator will
light up to indicate that the filter needs to be cleaned.
See the "Cleaning the Filter" section for more information.
Automatic Defrost
If the dehumidifier operates for an extended time in low
temperatures, ice may form on the cooling coils. If this happens,
the dehumidifier compressor will turn off and the fan with run until
the accumulated ice has melted. When the coils are completely
defrosted, the compressor or fan (depending on the model) will
automatically restart and dehumidification will resume.
Emptying the Water Bucket
WARNING
Sickness Hazard
Do not drink water collected in water bucket.
Doing so can result in sickness.
When the water collection bucket is full, the Bucket Full indicator
will light and the dehumidifier will turn off. The dehumidifier will
not function until the water bucket is emptied and replaced.
When the bucket is removed from the machine, the compressor
will turn off, but the fan will continue to run for a few minutes.
This is normal. The dehumidifier will not be removing moisture
from the air at this time.
1.
Remove water bucket
Remove the water bucket by pulling it straight out from
the bottom front of the dehumidifier. The bucket features a
convenient carry handle for easier transport.
NOTE: Do not place a full bucket on the floor, as the bottom is
uneven and the bucket may tip.
2.
Empty water bucket
NOTE: Hold the water bucket with both hands when emptying.
Empty the water bucket into a sink or drain.
Slide the water bucket back into the dehumidifier.
Water
bucket
7

Publicidad

loading