Publicidad
Idiomas disponibles
Idiomas disponibles
3. Rotate U-support (#21) that is on bottom of Table
Top Assembly until you see the screw holes in the
slots of U-clips (#22). Slide U-support (#21) side
to side if necessary to see holes. See figure 3.
4. Insert Screw (#35) through slot in U-clip (#22)
and into U-support (#21). See figure 3. Thread
screw all the way into U-support until it touches the
back of the tube. There should be about 3/8" of
screw (#35) left sticking out. Repeat for other
screw as shown in figure 3.
5. Repeat steps 3 and 4 on other table top assembly.
Note: Slide U-Support back and forth
until you see the hole if necessary.
Table Top
Assembly
With at least 2 adults,
slide Table Top Assembly
onto Strut Tubes
17
Strut Tube
Figure 4
22
7
7
35
21
AT LEAST TWO (2) ADULTS ARE NEEDED TO
COMPLETE THE REST OF THIS ASSEMBLY! WHEN
ASSEMBLING TOPS TO BASE, HANDLE TOP
ASSEMBLIES BY GRASPING ONLY THE TOPS
THEMSELVES. DO NOT GRASP METAL LEGS, U-
SUPPORT, LINKAGE, OR HINGES. THESE PARTS
CAN MOVE AND COULD PINCH FINGERS OR
HANDS CAUSING SERIOUS INJURY! ASSEMBLE
AS SHOWN WITH LEGS FULLY CLOSED AND
TOPS IN A VERTICAL POSITION. DO NOT OPEN
21
LEGS AND TRY TO ASSEMBLE. TABLE TOPS ARE
U-Support
HEAVY - DO NO T ATTEMPT TO ASSEMBLE
ALONE!
17
Strut Tube
6. Attach Table Top Assembly to Base Assembly (that
PIVOT STRUT
you put together in steps 1 & 2), as shown in figure
TUBES UP
4. Pivot Strut Tubes (#17) up as shown; then, with
at least one adult on each side of Table Top, lift top
and align ends of U-support tube (#21) with tops
of Strut Tubes (#17) on Caster Beams (#7) as
shown in figure 4. Slide tubes together.
DO NOT OPEN THE TABLE TO PLAYING POSITION
UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE
TABLE STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.
4
35
Table Top
Assembly
Figure 3
21
U-Support
Publicidad
