Publicidad
Idiomas disponibles
Idiomas disponibles
7. Screw U-support tube (#21) to Strut Tubes (#17) with two
Screws (#33) as shown in figure 5. Align holes in U-support with
holes in Strut Tubes and thread screw (#33) into hole in Strut
Tube (#17) Tighten screws all the way but be careful not to over
tighten. You could strip threads on screws if you over tighten.
Note: Due to shipping requirements the hinge (#18) may be positioned as shown in
detail A, you will have to rotate the hinge to the position shown in detail B. DO NOT
unscrew the hinge, you can rotate the hinge without unscrewing it from the table.
If you want to see a video on how to position hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
8. Attach Hinges (#18) to Strut Tubes (#17) as shown in figure 5,
Detail B. With hinge positioned as shown, align hole in hinge
with hole in Strut Tube and attach with ¼" Screw (#30), Plastic
Washer (#38) and Locknut (#34). Plastic Washer (#38) goes
between Strut Tube and Hinge. Tighten nut securely. Repeat for
other Hinge. CAUTION: Hinges must be positioned
exactly as shown or table will not operate correctly and
could be damaged. DO NOT take Hinges off.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
ATTENTION: If hinge is positioned as
shown below (Detail A), Rotate the hinge
as shown in Detail B. Do not take hinge off.
18
Detail A
Shipping position
of hinge
CAUTION: Position hinges exactly as
shown in Detail B or table will not operate
correctly and could be damaged.
Detail B
30
18
Assembly
position of hinge
16
17
29
34
38
16
17
30
18
Hinge Assembly
9. Attach Linkages (#16) to Leg (#19) as shown in
figure 5. Pivot one Linkage (#16) up and pivot Leg
out from top and align hole in Linkage with hole in
Leg (#19). Attach Linkage (#16) to Leg (#19)
using Hex Head Bolt (#29), Spacer (#37) and
Locknut (#34). Spacer (#37) goes between
Linkage and Leg. Attach other Linkage to Leg the
same way. Tighten nuts securely.
10. Attach Corner Protector (#40) to table corners.
Push snap tabs on Corner Protector into holes in
rails. Be sure that tabs are aligned with
holes before pushing. You could break tabs if
they are not aligned correctly.
11. With at least two adults, repeat steps 6
.
through 10 for other table top assembly.
Figure 5
34
34
37
21
33
17
17
34
38
Hinge Assembly
5
40
19
29
Spacer goes between
Linkage Arm (#16) and
Leg (#19)
16
33
30
38
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
18
37
Publicidad
