Ego Power+ OSA1000 Manual Del Operador página 6

PREPARATION FOR START
EN
Notice:
Wear non-slip gloves for maximum grip and
protection. Never stand directly under the branch you are
shaking. Make sure that you have a secure and balanced
footing. Watch out for obstacles such as tree stumps, roots
and ditches, which could cause you to trip or stumble.
Notice:
Maintain a proper grip on the unit whenever the
motor is running. Hold the unit firmly with both hands.
Notice:
Pay attention to the tree's limb structure during
operation. Do not be too close to the olive tree when you
operate. It's easy to get hurt if you get too close.
TO START/STOP THE TOOL
See "STARTING/STOPPING THE POWER HEAD"
section in the power head PH1400E operator's manual.
BASIC HARVESTING PROCEDURE (Fig. B)
1. Pay attention to the tree's limb structure during
operation:
◾
Comb the lower section (A) from the top downwards,
this also applies to the outer branches of the tree that
hang down.
◾
Comb the top part (B) upwards from the bottom.
◾
Comb from the inside of the tree to the top of the
branch.
2. While combing the branches, rotate the tube back and
forth on axis (C) if necessary.
3. Shake the whole tree even if there is very little fruit left
on it.
4 Do not fix the machine in one place for too long to
avoid damaging unnecessary leaves and branches.
5. Always switch off the machine when no one is on duty.
MAINTENANCE
WARNING: To prevent serious personal injury,
remove the battery pack from the tool before servicing,
cleaning, changing attachments or removing material
from the unit.
WARNING: When servicing, use only identical
replacement parts. Use of any other parts can create a
hazard or cause product damage. To ensure safety and
reliability, all repairs, other than the items listed in these
maintenance instructions, should be performed by a
qualified service technician.
6
OLIVE SHAKER ATTACHMENT — OSA1000
To assure a high performance for a long-time, operator
has to make a simple maintenance work as mentioned in
the following table.
POS. COMPONENT ACTION
1 Carbon rods Check if
assembled
correctly
2 Piston Grease through
the proper
opening
3 Olive Shaker Cleaning after
use
NOTE: The inside mechanisms of olive shaker are
protected for a lifetime with a special grease. DO NOT
OPEN THE MACHINE UPPER PART. Any tampering will
invalidate the manufacturer warranty.
REPLACEMENT
1. Loosen the 10 fixing bolts on the comb with Allen key
respectively.
2. Hold the black shock absorber and pull the tine out
outward, then 10 carbon rods be pulled out together.
Replace the new tine or shock absorber directly, then
insert it into the fixing hole on the comb and tighten
the retaining bolt.
3. If only one tine is damaged, simply loosen the retaining
bolt at the root of the tine. Hold the black shock
absorber with your hand, draw the damaged tine
separately and pull it out.
Pass the new tine through the black shock absorber,
then insert into the fixed hole corresponding to the
comb. Press it to the bottom and simply re-tighten the
retaining bolts. (Fig. E)
Protecting the environment
WEEE (Waste Electrical and Electronic
Equipment)
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for separate
collection. Electric tools must be returned
to an environmentally compatible recycling
facility.
FREQUENCY
Daily
3 times a day
Daily