Descargar Imprimir esta página

Orbegozo KT 6040 Manual De Instrucciones página 12

Ocultar thumbs Ver también para KT 6040:

Publicidad

Idiomas disponibles

Idiomas disponibles

KT 6040
Farms.
o
By clients in hotels, motels and other residential
o
environments.
In environments such hotel room
o
INSTRUCTION FOR USE
• Before first use,fill the kettle with clean water to maximum capacity and boil.Discard the water and
repeat the process.
• The kettle should always be unplugged when filling or adding water.
• Fill the kettle with water to desired level.Do not overfill or there will be a risk of spillage or
spitting.The water level indicator will assist you to measure the correct amount.You can fill the kettle
via the spout or after opening the lid.Do not forget to close the lid after filling,otherwise the kettle
will not automatically switch off after use.
• Do not fill with less than 0.5 liters of water(to "min" indication)to prevent the kettle running dry while
operating.
• Do not fill with more than 1.8 liters of water(to "max" indication).
• An automatic safety cut-out has been fitted for protection against overheating,it will operate if the
kettle is switched on when containing insufficient water.Always ensure the water inside the kettle
covers the minimum mark on the water level indicator gauge.If the automatic safety cut-out has
operated,switch the kettle off,disconnect from the power outlet and allow the kettle to cool down for
5 to 10 minutes.The refill with and switch on,the kettle will work as normal.
KETTLE
• Place the power base on a dry, flat surface. Place the kettle on the power base. The electrical connection
will be made automatically as the kettle slides onto the power base. Plug the cord set on the power base.
The electrical connection will be made automatically as the kettle slides onto the base.
• Plug the cord set into an earthed power socket and switch on by depressing the switch of the kettle to
the "on" position.
• When the water has boiled, the kettle will switch off automatically, after allowing the kettle to cool down
for 1 minute, the water can be brought back to the boil by pushing the switch back to the "on" position.
During the cooling down time do not force the on/off switch into the "on" position as this can damage
the operating mechanism.
• Do not remove the kettle from the power base without switching off first.
• Remember, if you do not wish to re-boil the kettle, switch it off.
• The kettle may be switched off manually at any time by setting the on/off switch into the "off" position.
• To pour water, lift the kettle from the power base and pour.
12

Publicidad

loading