Publicidad
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
lavatory
bidet
Hole size in mounting
surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this unit
be installed by a licensed, professional plumber.
• Inspect this faucet thoroughly before installation.
Claims for shipping damage made after installation
will not be honored.
• Please read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• The drain is suitable for most, but not all, lavatory sinks
sold in the United States and Canada. This drain is
intended for use in a sink with an overflow. If your sink
does not have an overflow, or if this drain is too small
for the hole in your sink, please refer to the instructions
included with the sink. Some sinks include special drain
installation instructions and/or parts. Others require the
use of a specialty drain. Hansgrohe is not respnsible
for the cost of a specialty drain.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 l/min)
1.5 GPM (5.7 l/min)
1⁵⁄₁₆" - 1⁷⁄₁₆" (34-37 mm)
1⅛" (30 mm)
• Model #72210XX1, 72211XX1 only: The
discharge water temperature from a bidet fitting shall
be limited to a maximum temperature of 110ºF (43ºC)
by a water temperature limiting device conforming to
ASSE 1070.
• The hot and cold supply hoses included with
this faucet are for use with ⅜ stops. If your
stops are a different size, install new stops. Adapters
are not available from Hansgrohe.
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.
Publicidad
