Milwaukee 5263-20 Manual Del Operador página 4

SPECIFICATIONS
Cat. No. ..................................................... 5263-20
Volts .............................................................120 AC
Amps ..................................................................5,5
No Load RPM ............................................. 0 -3700
No Load BPM ............................................ 0 - 4400
Type ......................................................... SDS Plus
Capacities
Rotary Hammer (concrete)
Carbide Tipped Percussion Bit ..................... 5/8"
Drill Only
Twist Drill Bit (Wood) ....................................... 1"
Twist Drill Bit (Steel) ..................................... 1/2"
FUNCTIONAL DESCRIPTION
4
3
2
1. Side handle
2. Clamp
3. Depth gauge
rod
4. SDS Plus
bit holder
5. Mode selector
lever
6. Trigger
7. Control switch
8. Handle
ASSEMBLY
To reduce the risk of injury, always
WARNING
unplug tool before changing or
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or
hold securely.
Adjusting the Side Handle Position
1. Loosen the side handle by unscrewing the side
handle grip until the side handle rotates freely.
2. Rotate the side handle to the desired position.
3. Tighten the side handle grip securely.
Setting the Depth Gauge
1. Press in the clamping lever.
2. Slide the depth gauge rod backward or forward
until it is set for the desired depth.
NOTE: The drilling depth is the distance between
the tip of the bit and the tip of the rod.
3. Release the clamping lever.
To reduce the risk of injury, do not
WARNING
grasp the bit while the chuck is
rotating or while the bit is falling from the chuck.
5
6
7
8
1
Installing Drill Bits and Chisels
Only use accessories with SDS or SDS+ shanks.
Be sure that the shank of the bit is clean. Dirt particles
may cause the bit to line up improperly. Do not use
bits larger than the maximum recommended capacity
of the drill because gear damage or motor overload-
ing may result. For best performance, be sure that
the bit is properly sharpened and the shank is lightly
greased before use.
1. Insert the bit or chisel into the nose of the tool.
2. Rotate bit slowly until it aligns with the locking
mechanism.
3. Push bit into tool until it locks.
4. Check that the bit is locked
properly; it should be possible to
pull the bit back and forth slightly
(about 1/4").
5. To remove bits and chisels, pull
bit holder release collar toward
the rear of tool and remove
bit.
NOTE: Use caution when handling hot bits and
chisels.
OPERATION
To reduce the risk of injury, always
WARNING
unplug tool before attaching or
removing accessories or making adjustments.
Use only specifically recommended accessories.
Others may be hazardous.
To reduce the risk of injury, wear safety goggles
or glasses with side shields.
To reduce the risk of injury, wear a dust mask or
use an OSHA compliant dust extraction solution
when working in dusty situations.
To reduce the risk of injury, keep hands and cord
away from the bit and all moving parts.
To reduce the risk of injury, always use a side
handle when using this tool. Always brace or
hold securely.
Selecting Action
These MILWAUKEE Rotary Hammers have two set-
tings: rotation only and rotary hammering.
1. For rotation only, turn the selector lever so the
arrow on the lever points to the twist drill symbol
.
2. For rotary hammering, turn the selector lever so
the arrow points to the hammer and twist drill
symbol .
4
Release collar