Fault Indications And Rectification Of Faults; Disposal Of The Old Device - Caso WineDuett Touch 21 Manual De Instrucciones

17.2 Fault indications and rectification of faults

The following table assists in localizing and rectifying minor faults.
Fault
The Device is not cold enough
The light does not work
Vibrations
The device seems to make too
much noise
The door will not close properly.
LED display does not show up
LED display error - Lo
Buttons are not functional.
► If you are unable to solve the problem with the steps shown above, please
contact Customer Service.

18 Disposal of the Old Device

Old electric and electronic devices frequently still contain valuable materials. However, they
also contain damaging substances, which were necessary for their functionality and safety.
If these were put in the non-recyclable waste or were handled incorrectly, they could be
detrimental to human health and the environment. Therefore, do not put your old device into
the non-recyclable waste under any circumstances.
► Utilise the collection point, established in your town, to return and recycle old electric and
electronic devices. If necessary, contact your town hall, local refuse collection service or
your dealer for information.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The device does not have the correct clearance.
The fan cover is dirty. Please clean the fan cover.
Please call the warranty service number
Check to ensure that the device is level
The device is not level. Also,please check the fan.
The device is not level.
The door is not properly installed.
The seal is weak. The shelves are out of position.
Main control board does not work.
PCB problem. There is a problem with the plug.
PCB problem, please contact customer service.
Temperature controller panel is damaged.
Please note
Please note
Possible Cause
35