Publicidad
Idiomas disponibles
Idiomas disponibles
LED Light Indicator
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed.
WARNING: To turn on the
light, press the On/Off switch
and make sure the Forward/Reverse
Rotation Control is on right/left
position.
The tool and battery are equipped
with a protection system. When the
LED Light is quickly flashing and turn
off, the system will automatically cut
off power to the tool to extend battery
life. The tool will automatically stop
during operation if the tool and/or
battery are placed under one of the
following conditions:
• Overloaded (The LED light quickly
flashes for 4-6 times and turn off):
The tool is operated in a manner that
causes it to draw an abnormally high
current. In this situation, release the
On/Off Switch on the tool and stop
the application that caused the tool
to become overloaded. Then pull the
On/Off Switch again to restart.
• Overheated (The LED light quickly
flashes for 9 times and turn off):
Under the condition above, if the tool
does not start, the Tool and Battery
are overheated. In this situation, let
the Tool and Battery cool before
pulling the On/Off Switch again.
• Low battery voltage (The LED light
quickly flashes for 2 times and turn
off): The remaining Battery capacity
is too low and the tool will not
operate. In this situation, remove and
recharge the Battery.
6.PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON WHEN YOU
PRESS THE SWITCH?
The Forward/Reverse Rotation Control, which is on
top of the On/Off Switch, is positioned in the lock
function. Unlock the Forward/Reverse Rotation
Control by putting it into the required rotation
position. Push the On/Off Switch and the drill will
start to rotate.Check that the battery is charged and
properly connected to the tool.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
20V Cordless Sub Compact Brushless Drill Driver
Verify the position of the torque adjusting ring. Find
the torque adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque (screw
driving force) and position 18 is the highest torque
(screw driving force). Position
Regulate the torque adjusting ring to a higher
position to reach the best result.
3. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not
used a battery pack for a prolonged time will reduce
the battery pack working time. This can be corrected
after several charge and discharge operations by
charging & working with your drill. Heavy working
conditions such as large screws into hard wood will
use up the battery pack energy faster than lighter
working conditions. Do not re-charge your battery
pack below 32°F (0°C) and above 104°F (40°C) as
this will affect performance.
See Fig. G
7.MAINTENANCE
Remove the Battery Pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through
the ventilation slots. This is normal and will not
damage your power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C (32°F-113°F).
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C
(32°F-104°F).
is for drill operation.
EN
13
Publicidad
