Publicidad
Idiomas disponibles
Idiomas disponibles
3 Tighten the screw to fasten the nose when a suitable
position is reached for a nailing test.
4 Connect the air hose.
Always wear eye protector.
Perform a nailing test.
5 Disconnect air hose from Nailer.
6 Choose a suitable position for the nose.
CHANGING THE EXHAUST DIRECTION
● When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and lock lever, and disconnect the air hose
from the Nailer.
The direction of the exhaust vent can be changed by
turning the top cover.
Exhaust
vent
USING THE NOSE CAP
● When attaching or detaching the nose cap,
lock the trigger, and be sure to remove your
fi nger from the trigger and lock lever, and
disconnect the air hose from the Nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the nose, attach the
accessory nose cap to the nose.
1 Disconnect air hose from Nailer.
2 Attach the nose cap to the nose with the arrow mark
on the cap facing toward the front.
3 When not using the nose cap, secure in the storage
compartment located on the reverse side of the
magazine.
NOTE
The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
WARNING
Exhaust
cover
WARNING
Nose
2
Nose cap
Arrow
Allen wrench for M4 screw
REMOVING THE NAILS
● Before removing the nails, be sure to remove
your fi nger from the trigger and lock lever,
and disconnect the air hose.
(1) When 15 or more nails remain
○ Depress the stop lever and pull out the magazine
cover.
○ Remove the nails from the magazine.
(2) When fewer than 15 nails remain
○ Remove the nose using the 3 mm Allen wrench stored
in the back-end of the magazine.
○ Remove the nails from the guide surface of the blade
guide.
(See section 1 of "MAINTENANCE AND INSPECTION"
on page 16)
NOTE
When fewer than 15 nails remain, use caution as it is
hard to see the remaining nails in the blade guide.
English
1
Disconnect air
Outlet
hose
Nose cap
WARNING
15
Publicidad
