Publicidad
Idiomas disponibles
Idiomas disponibles
The tool should only be used as a handheld hand operated tool. It is always recommended
that the tool is used when standing on the solid floor. It can be used in other positions but before
any such use, the operator must be in a secure position having a firm grip and footing and
be fully aware that when loosening fasteners the tool can move quite quickly away from the
fastener being undone. An allowance must always be made for this backward movement so as
to avoid the possibility of any hand/arm/ body entrapment.
Fit securely to the tool the socket or attachment required to perform the operation. Ensure
that the reverse button situated on the opposite side to the square drive output shaft is in the
correct position for tightening or loosening the fastener. The nut/ bolt can then run down the
thread using the power drive of the tool. When the tool stops the handle of the tool can be used
as a ratchet lever and operated to give the required tightness of the joint. For loosening a joint
the tool can be used in the reverse sequence.
Use a clean lubricated air supply that will give a measured air pressure at the tool of 90 PSI
with the trigger fully depressed.
Use recommended hose size and length. It is recommended that the tool is connected to the
air supply as shown in figure A.
Do not connect the tool to the air line system without incorporating an easy to reach and
operated shut off valve.
It is strongly recommended that an air filter, regulator, lubricator (FRL) is used as shown in
figure A as this will supply clean,
lubricated air at the correct pressure to the tool. Details of such equipment can be obtained
from your supplier. If such equipment is not
used then the tool should be lubricated by shutting off the air supply to the tool,
depressurising the line by pressing the trigger on the tool.
Disconnect the air line and pour into the intake bushing a teaspoon (5 ml) of a suitable
pneumatic motor lubricating oil preferably
incorporating a rust inhibitor. Reconnect tool to air supply and run tool slowly for a few
seconds to allow air to circulate the oil.
If tool is used frequently lubricate on daily basis and if tool starts to slow or lose power.
1) Inspect the air hose for cracks or other problems. Replace the hose if worn.
2) Never point an air hose at another person.
3) Disconnect the tool when not in use, or before performing service or changing accessories.
4) Use proper hoses and fittings. Never use quick-change couplings attached at the tool.
WORK STATIONS
INITIAL OPERATION
AIR SUPPLY
SAFETY RULES FOR AIR TOOLS
11
Publicidad
